Simple introduction and advantages of bottle blowing machine

Our plastic containers produced a series of fully automatic bottle blowing machine is suitable for any shape in blowing in PET, PE, PC, PP and other thermoplastics as raw material, widely used in irrigation bottle blow carbonated beverage bottles, mineral water bottles, oil bottles, pesticide bottles, cosmetics bottles, large caliber bottle and heat. The bottle blowing machine adopts automatic tube embryo system, fan opening film, reduce the cylinder stroke and bore, improving the production speed, reasonable design, to achieve full automatic production, less investment, quick effect, convenient operation and maintenance, on-site installation, commissioning, training. Perfect quality assurance, full service, let you buy the use of two rest assured.

This series of bottle blowing machine is suitable for the hollow molding of PET raw material by polyester blowing, and it can also be applied to other thermoplastic bottle grade plastics. Such as PC, PE, PP, PS, AS and other plastics. Now to the market is to integrate the advanced transmission equipment and automatic control technology at home and abroad.

Zhangjiagang Yu Cheng Machinery Co., Ltd. is a professional manufacturer of blow molding machines. The series automatic bottle blowing machine has the characteristics of fast production speed, smooth operation, small power consumption, small volume, low cost, long service life, convenient maintenance and safety.

The advantages of the bottle blowing machine:

1. small size, power consumption, operation and maintenance convenient.

2. advanced PLC control system, time control can be accurate to 0.01 seconds.

3. special air storage device.

4. infrared bottle heater.

5. different heating lamps are equipped with an independent temperature control device to ensure that the bottle embryo has an ideal heating effect.

6. the direction of the heating lamp tube can be adjusted according to the different bottle embryos.

9. the mechanical operation of the bottle is only one person, and no special training is required.

10. installation, start simple.

The scrap rate of 11. finished products was less than 0.2%.